Skip to content

Keyboard tester

Press any key. It lights on the keyboard below while you hold it and stays marked once it has registered, so you can see at a glance which keys work and which do not.

Last key
None yet
Code
None yet
Location
None yet
Tested
0 of 104
Held now
0
Most at once
0
Layout

Testing is on, so Tab, Space, the arrows and the function keys stay on this page. Press Escape twice quickly to pause and use the keyboard normally.

This test needs a physical keyboard. On a phone or tablet, connect one by cable or wireless and press its keys.

Press any key to begin. Each key lights while held and stays marked once it has registered.

How to test a keyboard

Work across the keyboard one row at a time, pressing each key once. Start with the function row, then the numbers, the three letter rows, the bottom row, and finish with the arrows, the navigation keys and the numpad. Press the left and right Shift, Ctrl and Alt separately: they are different switches and the readout tells you which side fired. When the counter reaches the total, every key on the layout has registered.

Then hold each key for a second. A healthy key lights once and goes dark when released. A key that flickers while held, or lights twice from one press, has a worn or dirty switch.

Ghosting and key rollover

Key rollover is the number of keys a keyboard can report at the same time. Many membrane keyboards guarantee only two and manage more for some combinations. A keyboard described as 6-key rollover reports six keys plus modifiers, and n-key rollover reports every key you can hold.

Ghosting is what happens past that limit: a held key is dropped, or on older designs a key you never touched is reported. To check, hold keys down one after another and watch the Held now and Most at once figures. If you are holding four keys and only three are lit, that combination is blocked. Try the groups you use together, such as W, A, S and D with Shift and Space, or the letters in a fast typing roll.

When a key does not register

First rule out software. Reload the page, click on it once so the browser has focus, and try the key again. Unplug and reconnect the keyboard, or try another port. For a wireless keyboard, replace or charge the batteries and pair it again. If the key works here but not in one program, the fault is in that program's settings, not the keyboard.

If the key is still dead, turn the keyboard over and tap out loose debris, then blow between the keys with compressed air. A key that works only when pressed hard or at one edge usually has dirt under the cap or a failing switch. A whole row or column that stopped at once points to the cable, the connector or the circuit underneath, which normally means repair or replacement.

Laptop and external keyboards

Laptop keyboards usually have no numpad and place the navigation keys on a function layer, so use the compact layout and ignore keys your machine does not have. If a laptop key has failed, plug in an external keyboard and test that too: when the external one works, the laptop's own keyboard is at fault and the rest of the machine is fine.

Once every key checks out, measure your speed with the typing test, or put the keyboard to work on the typewriter.

Keyboard test questions

How do I test my keyboard online?

Open this page on the computer the keyboard is connected to and press each key once. A key lights while you hold it and stays marked after you let go. The counter shows how many keys have registered, and the line under the keyboard names the ones still to press.

Why does a key not light up when I press it?

Either the browser never received the key, or the system used it first. Keys such as Print Screen, the Fn key, media keys and some function keys are often handled by the operating system or the keyboard itself and are never sent to a web page. If an ordinary letter or number does not light up, test again after cleaning the key and reconnecting the keyboard.

Can I test a laptop keyboard with this?

Yes. Choose the compact layout if your laptop has no numpad. The Fn key cannot be tested by any web page, because the keyboard handles it internally and sends nothing to the computer for it.

My keyboard layout is not ANSI or QWERTY. Does the test still work?

Yes. Keys are matched by their physical position, not by the character they type, so the key to the right of Tab lights the Q position on any layout. Keyboards with extra keys, such as the one beside the left Shift on ISO boards, still register: the code of that key appears in the readout even though it is not drawn.

Is anything I type sent or stored?

No. The page only reads which key was pressed in order to light it. Nothing is uploaded or saved, and Reset or closing the tab clears the result.